Archive for the '3D Printing' Category

Usagi

Feb 05 2019 Published by under 3D Printing

My hard drive crashed after sculpting him, so I redid it from scratch using my own screenshots as reference images.


No responses yet

Fixing up the turtles

Feb 28 2015 Published by under 3D Printing

I made sculpts of the TMNT back in 2011, but back then I was really just learning how to sculpt. They had weird proportions and a few issues with the actual 3D prints (Raph was top heavy, Mike was fragile, Don wasn’t dynamic). I haven’t had much time to sculpt recently, but I did have enough to revamp them. I hope they print nicely.

Leonardo Heroclix
Michaelangelo Heroclix
Donatello Heroclix
Raphael Heroclix
TMNT Heroclix

2 responses so far

New52 Bane

Jul 04 2014 Published by under 3D Printing

I kind of like this guy’s design but it doesn’t make much sense. He has stitching on the site of his shirt and mask as if it’s supposed to allow expanding when he uses venom and pumps up. But then he were’s like a million belts, which would imply his clothes are loose.

Ah well. I’m over thinking this.

You are next!



I will break you!

3 responses so far

Slash and Old Hob

Jan 24 2014 Published by under 3D Printing

Slash and Old Hob duo from the IDW TMNT comics. Slash has a variant with his mask and claw.

Old Hob Heroclix

One response so far

Krang

Nov 17 2013 Published by under 3D Printing

So I needed to make a Krang to go with my Shredder, Bebop, and Rocksteady. I based him off of the most classic (and ugliest) design, even though he’s been redesigned since then. Someone suggested I make the brain removable for the print, but I think that would cause more problems than it’s worth. I’d have to squash him so he can easily fit in the belly casing. Also people would just lose him all the time. Once you lose the brain he’s just an awkward, fat guy in a speedo.

I would love to print him at giant size (Like 7 or 8 inches tall), but I think he’s fine just being a normal sized figure too. He tends to switch sizes while he fights.

Krang Heroclix

Mwahahaha!

No responses yet

Next »